Holley manual choke installation instructions

Manual Choke Models: A. Connect the choke control cable (Holley P/N ) to the choke actuation lever, and lock in place with the choke cable lock screw. B. Mount the outer sleeve to the cable clamp. C. Actuate the choke cable through its full range of motion to ensure full choke operation. Adjust, as necessary. HB CFM Hardcore Gray™ Ultra Street Avenger™ w/ Black™ Billet Parts Elec. Choke. INSTALLATION, TUNING, AND ADJUSTMENT MANUAL. R NOTE: These instructions must be read and fully understood before beginning installation. If this manual is not fully understood, installation should not be attempted. Failure to follow. Holley offers bolt-on installation with improved performance and appearance. Features: Classic Holley Finish - Ideal for Stock to Mildly Modified Vehicles - Easy Installation - Manual Choke - Vacuum Secondaries - Single Feed Fuel Inlet - % Wet-Flow Tested. Please Note: This Holley Carburetor will Not work on an AOD Automatic Transmission.

Manual Choke Diagram. Hi guys. I have a Holley () CFM vacuum secondary carb with an electric choke. I want to put a manual choke setup on it. I have one in a drawer full of dismantled Holley parts, so I wonder if anyone has a diagram showing how the put the manual choke together. Thanks. INSTALL 2 BARREL CARBURETORS: This is the same as the four barrel except for the following: Mount the choke cable bracket under the two rear mounting screws. Replace the offset lever and swivel assembly with the flat equivalent included in the package. R Holley Performance Products Printed in U.S.A. CHOKE INSTALLATION INSTRUCTIONS. I hate the holley electric chokes - they cool off too quickly and will choke the carb when you come back out of the grocery store and the engine is still warm. I found a holley carb tech site a week or two ago that explained how to remove the electric and install the manual choke. I'l see if I can find it.

Be sure not to put the fast idle screw in backwards like i did in the video. Sorry for the confusion. MANUAL CHOKE MODELS: A. Connect the choke control cable (Holley® P/N ) to the choke actuation lever, and lock in place with the choke cable lock screw. B. Mount the outer sleeve to the cable clamp. C. Actuate the choke cable through its full range of motion to ensure full choke operation. Adjust as necessary. 1. Install the carburetor-mounting studs in the proper location on the intake manifold carburetor flange. 2. Place the new carburetor flange gasket, provided with the carburetor, in the proper position on the intake manifold. 3. Place the carburetor on top of the flange gasket on the manifold. Install the hold down nuts and snug down progressively in a.